<!DOCTYPE html>
<html>
<head>
<title></title>
</head>
<body><div>Yep you can make them permanent. Create your config in /etc/wireguard/wg0.conf. Then run 'systemctl enable wg-quick@wg0' (assuming you're running systemd).<br></div>
<div><br></div>
<div>wg-quick takes care of interface creation, interface and endpoint IP addressing, routing, and peer keys; so you just create that file and then use 'wg-quick up wg0'. :)</div>
<div><br></div>
<div>I wrote a few blog posts on setting up wg to act as a bridge into a remote network; you can probably use a lot of the info from there to get you started: <a href="https://www.ericlight.com/wireguard-part-one-installation">https://www.ericlight.com/wireguard-part-one-installation</a><br></div>
<div><br></div>
<div>E</div>
<div><br></div>
<div id="sig66226376"><div class="signature">--------------------------------------------<br></div>
<div class="signature">Q: Why is this email five sentences or less?<br></div>
<div class="signature">A: http://five.sentenc.es<br></div>
<div class="signature"><br></div>
</div>
<div><br></div>
<div><br></div>
<div>On Sat, 22 Jul 2017, at 11:54, Sahil Gupta wrote:<br></div>
<blockquote type="cite"><div dir="ltr"><div>Sorry, my bad.<br></div>
<div>I copy paste configuration of Peer A in both Peer A and B in this email.<br></div>
<div>I will follow the advise of Jason.<br></div>
<div><br></div>
<div><div>I switched off both Laptops and now wg interface are gone.<br></div>
<div>I need to create them again.<br></div>
<div>Can we make these interfaces permanent so they will not go upon switching off the laptop?<br></div>
</div>
<div><br></div>
<div><div>I will mail again if problem still persists.<br></div>
</div>
<div><div>Thanks<br></div>
<div>Sahil Gupta<br></div>
</div>
</div>
</blockquote><div><br></div>
</body>
</html>