[WireGuard] Client changes endpoint port, why?

[Quan Zhou]

The logs didn't show up immediately after `make debug; sudo make install'.
Is there easier way to reload wg than rebooting, or deleting the interface?

On Mon, Jul 11, 2016 at 11:40 PM, Jason A. Donenfeld <Jason at zx2c4.com>
wrote:

> On Mon, Jul 11, 2016 at 2:16 PM, Jan De Landtsheer <jan at incubaid.com>
> wrote:
> > \o/ A LOT better now :-)
> > Great!
>
> Good to hear. I assume you tested with the snapshot I published this
> morning?
>
>
> >
> > I'll dig in deeper... Is there a way that the kernel module logs
> > connection/disconnection/ip migration ?
>
> You can get lots of junk in your dmesg if you compile with `make debug`.
> _______________________________________________
> WireGuard mailing list
> WireGuard at lists.zx2c4.com
> http://lists.zx2c4.com/mailman/listinfo/wireguard
>



-- 
Regards,

Quan Zhou
+------------------------+
|pub [expires 2019-05-04]|
|2C0C 4D88 E631 4C73 4C44|
|CDE0 C0E 5470 1D2D 3F3EE|
+------------------------+
|pub [revoked 2016-04-16]|
|44D2 0307 1643 E80F 2E31|
|F081 FAFA 6643 7F9F D46F|
+------------------------+
|quanzhou822 at gmail.com   |
|https://keybase.io/qzhou|
+------------------------+
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.zx2c4.com/pipermail/wireguard/attachments/20160712/a3f9993c/attachment.html>