disabling ipv6 with wg-quick

[ds at fastmail.fm]

Thanks, removing all ipv6 addresses from configs works. 

I was looking for a switch in wg-quick so I can use the same configs in
different networks but I work around this by editing the confs.
Thanks again.
 


On Thu, Nov 16, 2017, at 13:28, Jason A. Donenfeld wrote:
> Remove the v6 addresses from Address= and AllowedIPs=, and then
> you'll be set.> 
> --
> Sent from my telephone.
> 
> On Nov 16, 2017 11:04 AM,  <ds at fastmail.fm> wrote:
>> Hi,
>> 
>>  Is there a way to disable ipv6 when using wg-quick?
>> 
>>  If I have the following line on my conf file:
>> 
>>  Address = xx.xx.x.39/32,xxxx:xxxx:xxx:bb01::327/128
>> 
>>  wg-quick will fail with the following error:
>> 
>>   ~ 2   wg-quick up mullvad-se2
>>  [#] ip link add mullvad-se2 type wireguard
>>  [#] wg setconf mullvad-se2 /dev/fd/63
>>  [#] ip address add  xx.xx.x.39/3 dev mullvad-se2
>>  [#] ip address add xxxx:xxxx:xxx:bb01::327/128 dev mullvad-se2
>>  RTNETLINK answers: Permission denied
>> 
>>  I have ip6 disabled in my system.
>> 
>>  Removing xxxx:xxxx:xxx:bb01::327/128 works, but wg-quick still
>>  sets ups>>  some ipv6 routes `ip -6 ..` etc.
>> 
>>  Is there a way to use ipv4 only with wg-quick?
>> 
>>  Thanks.
>> 
>>  _______________________________________________
>>  WireGuard mailing list
>> WireGuard at lists.zx2c4.com
>> https://lists.zx2c4.com/mailman/listinfo/wireguard

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.zx2c4.com/pipermail/wireguard/attachments/20171120/5de4ff2f/attachment.html>